How To Install Vertical Deck Skirting

If y'all have a deck or porch that is off the basis, you probably know that the expanse below is usually not that bonny. This is why people often use some method to hide it.

At that place are dissimilar ways y'all can do this. Some people utilise lattice or vertical boards, but we wanted something different. We also wanted information technology to have the aforementioned wait as our porch railing.

We decided to create deck skirting made of horizontal decking boards with spaces in between.

For this project, I used pressure-treated 2x4s and 6″ decking boards.

Hither yous tin can see a before moving picture of our lower porch.

In this tutorial, I'm going to show you how I installed our horizontal deck skirting to match our porch railing. Let's become started!

Stride 1: Measure and Cut 2x4s

Each of the brick piers nether our lesser deck has dissimilar heights because the footing slopes from left to correct. So I measured each one from the lesser of the existing skirt board to the basis. This gave me the length I needed for each 2×4.

I used these measurements to mark and cut all of my 2x4s with a miter saw.

Step 2: Drill Pilot Holes

Adjacent I adamant the setback of the skirt from the front face of the piers. I held the 2×four in place and drilled a pigsty in the middle of the 2×4 all the way through so it made a mark on the brick.

Then I used a hammer drill to drill a hole into the brick on that marker. I drilled the hole about i/two″ deep.

Holding the 2×iv in place again, I screwed a Tapcon screw through the pigsty in the 2×iv and into the hole in the brick.

I placed a level on the side of the ii×iv to make sure information technology was plum.

Well-nigh the bottom of the 2×4, I drilled a second hole until I hit the brick. Then I switched to the hammer drill to continue drilling the pigsty into the brick.

Then I screwed a Tapcon into that hole.

Step 3: Measure out and Cutting Decking Boards

One time I had all of the 2x4s in identify, I measured the distance between each pier. I used these measurements to marking and cutting the decking boards.

Step four: Fasten the Decking Boards

Working in one section at a time, I started installing the decking boards. I decided that the thickness of the board would be a good amount of infinite to leave betwixt each one. And so I cutting a couple of small-scale pieces to utilise as spacers.

For the commencement board, I placed the spacer between the existing top skirt lath and the board I was installing. I used a finished nailer to tack the board onto the ii×4. And then I tacked on the other end.

Working my fashion down, I repeated this until I got to the ground.

Then I moved to the side by side section.

After I nailed on all of the boards, I went dorsum and used decking screws to properly secure the boards to the 2x4s. I put two screws in each stop.

The Finished Product

Here'due south a look at the finished deck skirting. I have to say, Brooke and I both are very happy with how everything turned out! Finishing this project also immune united states to continue our landscaping around the dorsum of the house.